Cypher Environmental- EarthZyme- Application

EarthZyme Main
Uses
Application
Soil Analysis
MSDS
Contact

Mountain Path

Widening of Roadway

The EarthZyme Process

Finished Stabilized Road

Optional Pavement Layer

1. UNSEALED ROADS AND SHOULDER TREATMENT
EarthZyme when used on unsealed roads creates a stronger, dense pavement, utilising higher clay contents and PI than would normally be suitable. Trials over the past four years show, that by incorporating EarthZyme during the water binding process, unsealed road maintenance has significantly been reduced, less dusting occurs and gravels may last two years longer before re-sheeting. These overall improvements save money and safety on unsealed roads. Many users have received favourable reports from their ratepayers.

2. SUB-GRADE
The effects of EarthZyme are greatest on natural clay insitu material. When applied to natural sub-grades, increases in CBR of 30% to 40% have been achieved. Increases of 4% to 5% density for the same compactive efforts and reductions in both O.M.C. and PI can occur. These improvements in soil strength can lead to a significant reduction of imported base gravels and costly transport.

3. BASE COURSE
Where base-course material is not of high quality and has too high a PI (clay content), EarthZyme may be used to increase the soils physical characteristics to a suitable seal standard. Significant savings have been achieved by improving base materials.

4. LIME AND CEMENT STABILIZATION
When used with lime or cement EarthZyme improves the effects of these additives sufficiently to reduce their quantities by 50%. The effects of lime and cement with EarthZyme mean the application rate may also be reduced by 50%.

BENEFITS OF THIS COMBINATION ARE:
a) Cost reduction in additives.
b) EarthZyme keeps density high.
c) EarthZyme assists workability. In some cases the rotary hoes are not required.
d) Contains sugars which retard EarthZyme /cement setting time, allowing compaction to meet density specifications.

TO APPLY
We need first to have pavement ripped to desired depth of treatment.
We then want to get additive into soil as early as possible. Product is applied with the water truck. If you would normally need an estimated four passes of the water truck to bring material up to optimum then we would put additive in the first two passes for the day. From then on use water only.The trick is to get even distribution of additive over the area to be treated.
The next stage is mixing. This can be done as simply as blade mixing or rotary hoe or other similar type machinery.
It is suggested that you fill the water truck before adding EarthZyme This will prevent frothing due to surfactant component of the mix.
It is also necessary to watch optimum moisture content carefully to prevent from going over wet. The additive will improve wetability, workability and penetration thus enabling us to reach optimum earlier.
EarthZyme has been designed so as to fit in with normal existing construction procedures. The product has 7 day setting time so it is possible to put product in the soil a day before putting the pavement down without fear of it setting or going off.

APPLICATION
Rate of application is worked on the volume of soil to be treated. The volume of water required to reach optimum moisture content is not a part of this formula.
Standard formula for EarthZyme quantity is as follows: One litre (0.26 gallons) of EarthZyme will treat 35.5m3 (46 yd3) of compacted soil.

FORMULA
Length of pavement x width of pavement x depth of treatment - divide by application Rate = litres of EarthZyme required.

L W D
eg. 1000m (3300 ft) x 7m (23 ft) x 0.100m (0.33 ft) divided by 35.5 (4725) App Rate = 20 litres (5.3 gallons).

Minimum Equipement Requirment

Motor Grader with Ripper	Water Truck
Vibratory Compactor	Rubber Tire Roller

Optional Recommended Equipment

Pulverizer Mixer & Sheepsfoot Roller